Products

General Tester

  • MEGGER MFT1700 | Multifunction Tester

    The MFT1700 series is a range of 3 instruments for testing low voltage electrical installations to BS7671. They provide all the tests required to complete the necessary electrical certification for industrial, commercial and domestic fixed wiring installations.

    View More
  • MEGGER DCM 3xx Series | ClampMeter

    There are four instruments in the DCM series of clamp- meters, including the 400 A a.c. current-only DCM310; the DCM320 which includes voltage and resistance measurement; the DCM330 Fork-Multimeter, which is an open fixed jaw design; and this, the DCM340. Capable of measuring a.c. and d.c. current up to 600 A; a.c. and d.c. voltage up to 600 V; resistance up to 400 ?; and frequency up to 400 Hz, the DCM340 is the most versatile in the range.

    View More
  • MEGGER DCM 2xxx series | ClampMeter

    There are three different current clamps in the DCM range covering many applications. The series starts with a plugin unit for basic a.c. current measurements made in conjunction with a multimeter, a volt plus current unit where the user needs the flexibility of being able to make voltage measurements as well as current measurements and a high current a.c./d.c. unit.

    View More
  • MEGGER LT300 | Earth Loop Impedance Tester

    The LT300 offers high current loop testing over a wide range of frequencies and supply voltages with simple, fast, two wire operation. It has a large clear display that aids visibility in poor conditions.

    View More
  • MEGGER PA9 Wireless | Power Quality Analyzer

    The new Megger PA9 Wireless is the latest innovation of the successful PA-9 Power Quality Analyzer platform. It simultaneously records power quality and power flow information. The PA9 Wireless incorporates newly enhanced key features including a wireless modem for remote communication, a full 12 MB of nonvolatile internal memory and standard auxiliary power input capabilities as well as an optional external flash card for added memory. The wireless modem allows the user to configure the unit remotely, view real-time data via the remote screen, and preview all recorded data without downloading the data.

    View More
  • MEGGER PA9 Plus | Power Quality Analyzer

    The Megger PA9Plus is the latest innovation of the successful PA-9 Power Quality Analyzer platform. It incorporates newly enhanced key features including a faster Digital Signal Processor (DSP) to support continually evolving capabilities, a full 12 MB of nonvolatile internal memory and standard auxiliary power input capabilities. To address worldwide requirements and applications, the PA9Plus is CE marked, supports several international languages, and adheres to applicable European and North American standards (EN50160, IEC61000-4-15, IEEE1159, IEEE519), including automatic phase lock loop synchronization of input frequencies ranging from 20 Hz to 70 Hz, flicker measurements and recording, and out of limits/frequency trending.

    View More
  • DCM300E Earth leakage clampmeter

    0.01 mA resolution EMC and IEC61010-2-032 compliance 30 mA, 300 mA, 30 A and 300 A range

    View More
  • LRCD210 and LRCD220 | Combined Loop and RCD Testers

    Non-trip loop tester RCD testing from 10 mA to 1000 mA Extremely easy and safe to use Built-in protective front cover Tough Rubber armoured case Weatherproof 3 year warranty

    View More
  • LTW315, LTW325 and LTW335 2 wire non-tripping loop impedance testers

    2 Wire Non-tripping loop tester 50 V to 440 V operation 110 V centre-tap loop testing CATIV installation testing AUTO start - operation 0.01 ? resolution

    View More
  • RCDT310, RCDT320 and RCDT330 | Residual current device testers

    Tests standard, DC and selective RCDs Ramp testing Auto (Remote) testing 3 Phase safe Enables testing on 110 V centre tapped supplies. Tough rubber armoured case with built-in cover Weatherproof to IP54

    View More
  • AVO®210 Electrician's multimeter

    2000 count digital display 1000 V DC / 750 V AC ranges 10 A AC / DC ranges Resistance, frequency and capacitance ranges Non-contact voltage detector CAT III 600 V

    View More
  • AVO®410 TRMS electricians' multimeter

    6000 count backlit digital display True RMS reading on a.c. mode 1000 V d.c. / 750 V a.c. ranges 10 A a.c. / d.c. ranges Resistance, frequency and capacitance ranges CAT IV 600 V safety rating

    View More
  • AVO®830 and 835 High-End Multimeter

    TRMS voltage and current measurement Dual digital readout Classic Megger analogue arc 0.1% basic accuracy 10 000 count resolution 4 ½ digits Phase sequence measurement for 3 phase circuit and motor testing 10 M? and 10 k? input impedance switching Non-contact live circuit detection with Hi/low sensitivity Resistance from 0.01 ? to 50 M?, conductance and Diode measurement Auto and manual range control Minimum, maximum and average measurement capture Measurement smoothing for fast changing quantity capture Hold and Auto Hold modes 800 Hz Low pass filter Capacitance and frequency measurement Temperature measurement* IP54 environmental protection

    View More
  • DCM1500 1500 A TRMS clamp meter

    DC and AC current up to 1500 A True RMS measurement for greater accuracy Large jaw size safely assists with uninsulated conductor measurements 750 Vac and 1000 Vdc Resistance , continuity and frequency Peak, min/max and data-hold functions

    View More
  • DCM305E Earth leakage clampmeter

    0.001 mA resolution Up to 100 A range for standard AC current measurements TRMS reading Low pass filter to aid stability of readings Auto, data and peak hold 40 mm jaw Analogue bargraph display for trending

    View More
  • DCM310 and DCM320 Digital clamp meter

    Option of current only , DCM310 or multimeter, DCM320 models Measures up to 400 A a.c. with low current ranges for improved resolution 600 V a.c./d.c. DCM320 20 M? Resistance DCM320 Data Hold Max Hold DCM310 Small pocket-size design Exceptional battery lifetime Supplied with carry case IEC61010 CAT III 600 V

    View More
  • DCM330 Fork Multimeter

    200.0 A a.c. open-jaw current measurement 0.1 V to 1000 V auto-ranging a.c. and d.c. voltage measurement 0.1 ? to 20.00 M? resistance range Continuity buzzer Diode check Non-contact detection of a.c. voltage CAT IV 600V

    View More
  • DISCONTINUED - AVO300 series Classic multimeter

    Designed for Electricians Fully auto ranging Large display characters Separate battery and fuse cover Data hold Min/Max store IEC 61010 compliant Suitable for applications to CATIII 600 V

    View More
  • PVK320 Photovoltaic kit

    PVM210 irradiance meter AVO410 CATIV TRMS multimeter C4 solar connectors to 4 mm standard plug test leads MC3 to MC4 adapter test leads PV kit storage pouch

    View More
  • PVM210 Irradiance meter

    Optimal incident angle and positioning of solar panels Measurement of solar power for panel short circuit calculation 33/4 digit LCD display with 1999 W/m2 range Single handed use Mini pocket size Standard camera mount fixing for accurate placement

    View More